nForce4 SLI Motherboards: Premium Performance at a Bargain Price
by Gary Key on January 3, 2006 12:05 AM EST- Posted in
- Motherboards
ASUS A8N-SLI Premium: Overclocking
FSB Overclocking Results
This board is a good overclocker at the standard ratio, but we could not break the 300fsb mark with a 1:1 memory ratio. We had to run the standard memory timings, although performance was still excellent at these settings. The board just would not overclock well with the CAS Latency set at 2 (1:1 memory timings), but it did not have issues with the HT running near 1200. We tried relaxing the memory timings, reducing the HT settings to 3x, and increased voltages to the maximum allowed, but we could not increase the fsb past 295 while completing our benchmark suite. We were able to overclock the fsb to 340 at the 9x multiplier, which resulted in CPU operation of 3066MHz, but we had to reduce the memory ratios to reach this level. The test system was able to boot into Windows at a setting of 350fsb x 9, but was not stable enough to complete our testing. At the settings listed, our test system was able to complete the entire benchmark suite three times without any reported issues.
Memory Stress Testing
Memory stress tests look at the ability of the Asus A8N-SLI Premium to operate at the officially supported memory frequencies of 400MHz DDR, at the best performing memory timings that the OCZ Technology PC4800 Elite Platinum could support. The default setting for Command Rate in the Asus BIOS is 2T. You need to set Command Rate manually to 1T for best performance with 2 DIMMs in Dual Channel mode.
The Asus A8N-SLI Premium was completely stable with 2 DDR modules in Dual-Channel at the settings of 2-2-2-5 at the default 2.8V.
Tests with 4 double-sided DIMMs on an AMD Athlon 64 system are very demanding, since AMD specifies DDR333 for this combination. However, most AMD Athlon 64 motherboards combined with recent AMD processors have been able to handle 4 DIMMs at DDR400 settings.
The Asus A8N-SLI Premium was completely stable with 4 DDR modules in Dual-Channel at the settings of 2-2-2-7 at the default 2.8V.
FSB Overclocking Results
Front Side Bus Overclocking Testbed | |
Processor: | Athlon 64, 4000+, San Diego Core |
CPU Voltage: | 1.5125V (1.4000V default) |
Memory: | OCZ PC4800 Platinum Edition |
Memory Voltage: | 2.95 |
Cooling: | AMD Stock Heat sink and Fan |
Power Supply: | OCZ Power Stream 520 |
Maximum CPU Overclock Standard Ratio (12) |
255fsb x 12, 5x HT, (2.5-4-4-10, 1T) 3064MHz (+27%) |
Maximum FSB Overclock Lowered Ratio (9) |
295fsb x 9, 4x HT, (2.5-4-4-10, 1T) 2661MHz (+47.5% Bus Overclock) |
This board is a good overclocker at the standard ratio, but we could not break the 300fsb mark with a 1:1 memory ratio. We had to run the standard memory timings, although performance was still excellent at these settings. The board just would not overclock well with the CAS Latency set at 2 (1:1 memory timings), but it did not have issues with the HT running near 1200. We tried relaxing the memory timings, reducing the HT settings to 3x, and increased voltages to the maximum allowed, but we could not increase the fsb past 295 while completing our benchmark suite. We were able to overclock the fsb to 340 at the 9x multiplier, which resulted in CPU operation of 3066MHz, but we had to reduce the memory ratios to reach this level. The test system was able to boot into Windows at a setting of 350fsb x 9, but was not stable enough to complete our testing. At the settings listed, our test system was able to complete the entire benchmark suite three times without any reported issues.
Memory Stress Testing
Memory stress tests look at the ability of the Asus A8N-SLI Premium to operate at the officially supported memory frequencies of 400MHz DDR, at the best performing memory timings that the OCZ Technology PC4800 Elite Platinum could support. The default setting for Command Rate in the Asus BIOS is 2T. You need to set Command Rate manually to 1T for best performance with 2 DIMMs in Dual Channel mode.
Asus A8N-SLI Premium Stable DDR400 Timings - 2 DIMMs (2/4 slots populated - 1 Dual-Channel Bank) |
|
Clock Speed: | 200MHz |
CAS Latency: | 2 |
RAS to CAS Delay: | 2 |
RAS Precharge: | 2 |
RAS Cycle Time: | 5 |
Voltage: | 2.8V |
Command Rate: | 1T |
The Asus A8N-SLI Premium was completely stable with 2 DDR modules in Dual-Channel at the settings of 2-2-2-5 at the default 2.8V.
Tests with 4 double-sided DIMMs on an AMD Athlon 64 system are very demanding, since AMD specifies DDR333 for this combination. However, most AMD Athlon 64 motherboards combined with recent AMD processors have been able to handle 4 DIMMs at DDR400 settings.
Asus A8N-SLI Premium Stable DDR400 Timings - 4 DIMMs (4/4 slots populated - 2 Dual-Channel Banks) |
|
Clock Speed: | 200MHz |
CAS Latency: | 2 |
RAS to CAS Delay: | 2 |
RAS Precharge: | 2 |
RAS Cycle Time: | 7 |
Voltage: | 2.8V |
Command Rate: | 2T |
The Asus A8N-SLI Premium was completely stable with 4 DDR modules in Dual-Channel at the settings of 2-2-2-7 at the default 2.8V.
37 Comments
View All Comments
Gary Key - Tuesday, January 3, 2006 - link
Hi,I have been informed by Blue Gears that the significant differences we are seeing is due to the current beta driver set. They recently released a 64-bit driver set that improved performance up 18% in some applications. The general C-Media driver that was provided last fall was in worse shape than the June beta for the 32-bit operating systems so they went back to the drawing board. If you go back and read some of our recent Intel reviews you will see that Realtek has improved their HD codec performance by up to 40% in some instances over the last three driver releases. The A380 release we utilized for the ALC850/655 was around 9% better in Serious Sam II and BF2 (not shown yet) over the A379.
I would not be concerned with their next card at this point. They are very customer focused and are doing everything possible to improve the performance of the C-Media driver sets.
yacoub - Wednesday, January 4, 2006 - link
Thanks for the replies, Gary. Looking forward to seeing better numbers. I totally understand what you mean about scenes breaking up. I experience that as I'm waiting for the new BlueGears card to come out later this month so I'm running the onboard ALC-8xx series audio on the A8N-SLI Premium I have. It's pretty crappy and sometimes heavy action scenes with lots of sound sources seem to chug the computer and now I see that's typical of the onboard solutions.yacoub - Tuesday, January 3, 2006 - link
Considering the surprisingly poor results of the BlueGears and CLabs X-Fi cards in the actual gaming tests, why do you state that like it's an "obvious" conclusion when the numbers state exactly the inverse - that the onboard audio solutions, as cpu-grubbing as they are, actually provide the better framerates in most of the games tested?
Unless your results are anomalic, I'll have to start my soundcard research all over again. I was sold on the upcoming X-Plosion but now that it doesn't really gain me much if anything in the way of cpu usage improvement during gaming (half the purpose of getting a peripheral soundcard to begin with), I only end up with better audio quality (the other half of the purpose) and for that, yes, the BlueGears card should be better than the X-Fi series, but I really want to get better cpu usage as well. Hmmmm...
Gary Key - Tuesday, January 3, 2006 - link
The audio quality of those two sound cards are significantly better than the Realtek ALC850/655 codecs across the spectrum. Their performance at times is worse in absolute numbers but the difference in consistent frame rates while playing on-line and within the game was significant from a subjective viewpoint. We are finishing our benchmark suite for showing (consistently) the low/average/high frame rates with sound enabled. I did not publish the BF2/F.E.A.R./HL2 numbers yet as we needed time to verify the benchmarks were repeatable with the latest patch updates. However, the two add-in cards scored better and have more consistent frame rates than the on-board sound solutions. In a couple of scenes in the BF2 benchmark the on-solutions would stutter and the scence would break up, this never happened with the add in cards.
The lastest SSII patch and Creative drivers should improved the scores even further in that game. In Serious Sam II we were quite surprised by the results and they shadowed the same results from the last Intel article. Although I can make out the near/far audio effects being played with a set of high end headphones on the ALC850 codec, it in no way compares to the sounds being played back by the XFI and Mystique. The sound on the ALC850/655 is tinny and muffled while you can hear exacting details in the same scenes with the other two cards. It is even more obvious in F.E.A.R and BF2, almost to the point of wondering if you were listening to the same audio playback.
Also, the on-board ALC850/655 solutions only support up to 26 buffers in the drivers.
Thank you.
Gary Key - Tuesday, January 3, 2006 - link
Really need an edit function, hit the button before I finished proof reading.
Spacecomber - Tuesday, January 3, 2006 - link
Shouldn't the game benchmarks, at least, have focused on performance running two video cards in SLI? There was some mention in the Final Words section of using two video cards on these boards; so, I got the impression that this might have at least been tried. Still, it comes across as an after-thought, which seems to miss the point of a thorough testing of what is the main feature of these boards.Just a bit puzzled.
Space
Gary Key - Tuesday, January 3, 2006 - link
Good Day,We will have SLI benchmarks up once we complete the SLI roundup that consists of several more boards between the $80~$140 range. I might modify the article to include our initial results between the three boards tested. The issue is previous boards were tested with the 78.x drivers while these boards were tested with the 81.85 driver set. There is a significant performance difference in several benchmarks between the two driver sets that would have been confusing. We have not gone back and tested all of the boards in SLI with the 81.85 up to 81.98 drivers yet.
deathwalker - Tuesday, January 3, 2006 - link
Odd that the Albatron and Foxxcon come out very satisfactory in the testing and the don't make the Motherboard roundup that came out only 2 days ago. Great review though and it nice to see that you can save a couple $ on off-brand mobos and still get a decent product.Gary Key - Tuesday, January 3, 2006 - link
We still have several more value to mid-range SLI products to review and as such any final recommendations will be done at the completion of the testing cycle.
Calin - Tuesday, January 3, 2006 - link
On the second page, in the table, all the boards have slots for DDR2 memory. It should be DDR, I think